Status Cable Free Battery Operated Door Chime White

This door chime uses self learning technology, with 1 million running codes to help prevent operating interference. with 32 selectable melodies: Within 24 polyphonic and 8 monophonic sounds to choose from.
Batteries: BEll push uses 1 x CR2032 3V Lithium battery (included). YHe main chime unit uses 3 x 1.5V AA batteries (not included).

Status® Quality Approved - Status International (UK) Ltd People in Pursuit of Excellence

Status

www.statusinternationaluk.co.uk
Status International (UK) Ltd,
Unit 1,
Whitehall 26 Business Park,
Heathfield Lane,
Birkenshaw,
Bradford,
BD11 2HW.

32 Melodies, 150 Metre range (approx.), 13A AMP Rated, AA batteries (not included), 3xAA batteries not included

Box

Status International (UK) Ltd,
Unit 1,
Whitehall 26 Business Park,
Heathfield Lane,
Birkenshaw,
Bradford,
BD11 2HW.

Safety Warning:
Battery Safety Guidelines: Only batteries of the same type or equivalent should be used. Batteries should be removed and replaced by an adult only. Insert batteries observing the correct polarity. Do not mix old and new batteries. Do not attempt to burn. Dispose of the discharged batteries safely. Use a collection point where available.

Do not use in damp or wet conditions. Main unit is for indoor use only. The 150 metre bell push to chimé unit range is unobstucted range and may be affected by walls and any other objects. If in doubt consult a qualified eléctrician.

BATTERY WARNING
KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion. Seek medical attention immediately.

Additional Information:
For electrical products sold within the European Community.

This wireless battery operated door chime is perfect for use around the horne, the chime unit is easily portable to take it with you to any room you are in. Featuring 150 metre range (approx.) from the main unit to the bell push allows for use in sheds and gardens when sat outside.
Main Unit Installation: With this door chime no wiring is required, it can be wall mounted or simply placed on a shelf or window ledge. For wall mounting, mark the fixing position using the hole on the back of the door chime as a guide. Insert a screw into your wall using wall plugs if required, then hang the door chime using the screw slot on the back of the unit. Before fixing, check that the bell push and main unit are within range and that the main chime unit responds to the bell push.
Bell Push Installation: Mark the fixing position in your desired location using the 2 mounting holes on the back of the unit and insert screws using wall plugs if required. This bell push also comes with a sticky pad that can be used for the placement instead of using screws. Simply peel the inside layer off the pad and secure on to the bell push then remove the outer layer and stick to your desired location (make sure all surfaces are clean and dry before application).

Battery Replacement: For the main unit remove the battery compartment cover by sliding it away from the unit, replace this cover after replacing the old batteries with new. To replace the batteries in the bell push, locate the open arrow at the end of the unit, using a small screw driver or pen tip, carefully push down on the locking clasp. Make sure to replace this with a clicking sound to ensure locking.

Pack - Recycle